Auto Seats - Seat Covers Install page

1. Pull the headrest out of the seat. Install each of the headrest covers. On some of the cars & trucks, (Ford, Chevy, GMC, Dodge) the headrest comes out buy using a paper-clip and pushing into the hole in the plastic grammet (CLICK HERE FOR PICTURE) located on the top of the seat.
2. Install the back part of the seat covers from upper side downwards and stretch it. Push snap part through the seat and snap to the back of the seat cover.
3. Sitting part of the seat covers can be installed by using hooks provided (Click to see picture) with the seat covers. Each sitting parts uses 5 hooks. After laying seat bottom, pull elastic with hook to left and right side of the seat, and tie under the seat cushion to spring if possible not to each other. Some seats have electric controls; covers can be installed behind the plastic panel using a coat hanger.

REAR SEATS:
Remove bottom and top part of the seats from the car. This can be done either by removing the screws/nuts or pushing the bottom towards the back seat so the seat can pop up. Most back parts of the seat have 2 screws. After removing them, push the seat upwards. Put the covers on both parts. Keep the pattern centered and aligned between the 2 parts of the seat. Use the hooks to tie the seats. Larger cover is for the upper part of the seat. 60x40 rears are easy to figure out.

You may also download a copy of our Installation Instructions (1 MB, Adobe Reader required).

You may also download a copy of our Seat covers Care Instructions (1 MB, Adobe Reader required).










FRONT SEATS: 1. Pull the headrest out of the seat. Install each of the headrest covers. On some of the cars & trucks, (Ford, Chevy, GMC, Dodge) the headrest comes out buy using a paper-clip and pushing into the hole in the plastic grammet (CLICK HERE FOR PICTURE) located on the top of the seat. 2. Install the back part of the seat covers from upper side downwards and stretch it. Push snap part through the seat and snap to the back of the seat cover. 3. Sitting part of the seat covers can be installed by using hooks provided (Click to see picture) with the seat covers. Each sitting parts uses 5 hooks. After laying seat bottom, pull elastic with hook to left and right side of the seat, and tie under the seat cushion to spring if possible not to each other. Some seats have electric controls; covers can be installed behind the plastic panel using a coat hanger. REAR SEATS: Remove bottom and top part of the seats from the car. This can be done either by removing the screws/nuts or pushing the bottom towards the back seat so the seat can pop up. Most back parts of the seat have 2 screws. After removing them, push the seat upwards. Put the covers on both parts. Keep the pattern centered and aligned between the 2 parts of the seat. Use the hooks to tie the seats. Larger cover is for the upper part of the seat. 60x40 rears are easy to figure out. You may also download a copy of our Installation Instructions (1 MB, Adobe Reader required). You may also download a copy of our Seat covers Care Instructions (1 MB, Adobe Reader required).